Tested using build 467 (prefinale candidate.

If you change selection from Show only local to Show local/remote and press apply and OK (but not Select all or manually
reselect)Hover help sources are not updated---> Hover Help is not working. You must also press Select all or select
manually after changing local--local/remote.

Date: 2009-09-15 08:58
Sender: Juha  Hentunen

Verified using build mica_esbox_pluthon_3.4.2_build.490.

Date: 2009-09-11 15:13
Sender: Fabricio Epaminondas

Hi Juha, 
as all preference pages just the last state of the configuration
page is saved, no matter if you select all nodes before, in your
last step you just enabled the "local doc nodes", so
no remote doc nodes will be pre-selected when you reopen the
page.

Date: 2009-09-11 05:29
Sender: Juha  Hentunen

It seems that check boxes are not updated properly.
Steps to reproduce:
1. Add Local help ( How to Download and Install Help Documentation,
see aattchment Hover_local.png)

2. Preferences-Maemo-Hover help: activate Show local/remote and
press Select all as in attachment Hover1.png.

3. Áctivate Show only local and press Apply and OK.

4.Open Preferences-Maemo-Hover help again and you see view like
in attachment Hover2.png.

Date: 2009-09-10 21:02
Sender: Fabricio Epaminondas

 About this bug, are you sure that all remote docs should be
automatically selected when user select "show local/remote"?
(remember that each node has multiple versions)
[[[ejs]]] It seems from Juha's report that changing the selection
may leave the set of documentation sources unexpectedly empty,
when it should be populated from remote.  I.e. in the case where
there is no local documentation at all.  Maybe it should be filled
in if the user changes the sources && the list was empty?
[[[ejs]]] Is this accurate, Juha?